How to give angle in autocad
- how to give angle in autocad
- how to give angle in autocad line
- how to give angle dimension in autocad
- how to give angle command in autocad
Enter the left angle bracket (<) and the angle, for example <45, and move the cursor to indicate the direction....
About Specifying Distances, Lengths, and Angles
When creating or moving objects, you can specify a point by moving the cursor to indicate a direction and then entering the distance.
To specify a line length without entering coordinates, you can specify the second point of the line by moving the cursor to indicate a direction and then entering the distance from the first point. You can also enter calculated distances and points using the QuickCalc calculator or the command line calculator (CAL).
Enter polar coordinates, for example 2.5<45.
You can use direct distance entry to specify points for all commands requiring more than one point. When the cursor is locked to an angle with Ortho mode or polar tracking is on, this method is an efficient way to create lines of specified length and direction, and to move or copy objects.
Specify an Angle Override
To specify an angle override, enter a left angle bracket (<) followed by an angle whenever a command prompts you to specify a point. The example below demonstrates how to specify a 30-degree angle override when you create a line.
Command: line
Specify first
- how to make angle dimension in autocad
- how to make right angle in autocad